Chair-supported split squat
Keep the whole foot supported. Bend within a controllable range, then stand without bouncing or collapsing inward.



Use secure hand support to control split stance and hinge positions; keep all work upright.
Work 1 → 6 in order, twice · each 45 s station = up to 30 s work + at least 15 s transition
Keep the whole foot supported. Bend within a controllable range, then stand without bouncing or collapsing inward.
Use only a fixed, load-bearing counter that cannot tip or slide. Lower the chest between the hands with the body moving as one unit.
Soften the knees and send the hips back. Keep any load close; stop before the trunk position becomes difficult to control.
Move the shoulder blades smoothly without lifting the ribs. Keep the neck relaxed.
Breathe throughout and keep the pelvis quiet. Shorten the lever or range before the back arches or the shoulders lose support.
Use a pace and route that keep steps controlled. Do not chase speed or breathlessness; leave space to slow down.

Readiness comes before the clock. Take extra preparation or pause whenever needed.
Follow exercises 1–6 in order, twice. Each 45 s station holds up to 30 s work and at least 15 s recovery or transition.
Effort: 5–7/10; finish with 2–4 good repetitions in reserve. These are 12 station exposures, not 12 maximal strength sets.
Use the easier option named on the exercise card, shorten the lever or range, and stop the work early. Pause the clock when additional recovery or setup time is needed.
Repeat this selection until the target can be completed with stable technique on two occasions. Then change one variable only: range, repetitions within the time cap, or modest resistance. Never progress just to fill the timer.
Keep the whole foot supported. Bend within a controllable range, then stand without bouncing or collapsing inward. Match both sides; the displayed dose is per side. Use about 3 s per repetition and up to 5 s to change sides; the cap includes both sides.
Easier: Chair sit-to-stand
Use only a fixed, load-bearing counter that cannot tip or slide. Lower the chest between the hands with the body moving as one unit. Use about 3 s per repetition unless a slower tempo is written. Stop when the target is reached.
Easier: Wall push-up
Soften the knees and send the hips back. Keep any load close; stop before the trunk position becomes difficult to control. Match both sides; the displayed dose is per side. Use about 3 s per repetition and up to 5 s to change sides; the cap includes both sides.
Easier: Wall-target hip hinge
Move the shoulder blades smoothly without lifting the ribs. Keep the neck relaxed. Unloaded drills train control, not a loaded row. Use about 3 s per repetition unless a slower tempo is written. Stop when the target is reached.
Easier: reduce range, resistance or work time.
Breathe throughout and keep the pelvis quiet. Shorten the lever or range before the back arches or the shoulders lose support. Match both sides; the displayed dose is per side. Do side 1, take up to 5 s to switch, then side 2. Rest for all unused time.
Easier: Wall forearm plank
Use a pace and route that keep steps controlled. Do not chase speed or breathlessness; leave space to slow down. Not a speed test. Recover for the remainder of the station.
Easier: reduce range, resistance or work time.
Equipment: Chair; Fixed countertop; Chair / counter; Wall
Inspect supports and clear the floor. Chairs, steps and benches must not tip or slide. No improvised doorframe anchors, glass weights or unverified hanging supports.
Unloaded shoulder-control drills do not provide the same progressive pulling load as rows. Do not treat this as a complete pulling-strength programme.
Stop any movement that causes sharp or increasing pain, dizziness or unusual breathlessness. No pain, calorie-burn or injury-prevention outcome is guaranteed.